澳门永利皇宫官方网网址(中国)NO.1

{pboot:sort scode=} [sort:name]
[sort:subname]
[sort:name]
{/pboot:sort}

Instructions for the use of lifting accessories wheel sets

2021.08.16

Crane parts depend on quality for seven points, and maintenance for three points.  In order to prolong the service life of crane components and help you to work better, Top Lifting specifically summarizes the following two aspects, hoping to help you.

Instructions for the use of wheel sets:

1. The position of the wheel should be such that the width center plane is consistent with the symmetric center of the two bearing boxes;

2. The bearing box support plane should be parallel to the center surface of the wheel width, and the deviation should not exceed 0.07mm;

3. The inclination of the wheels in the vertical direction should not be greater than 1mm;

4. The fit between the wheel and the axle should be firm, and the swing amplitude should not be greater than 0.10mm;

5. The driving wheels that rotate coaxially should be replaced in pairs, and the diameter deviation should not be greater than 0.0005 times the diameter.  The diameter deviation of the two wheels of the passive wheel is not more than 0.002 times of the diameter;

4. After disassembly and overhaul, it should be assembled in time.  After the assembly is completed, it needs to be tested before it can be used;

5 When replacing wheels, they should be installed and replaced strictly in accordance with the operating requirements.

Wheel replacement standard:

(1) If the shaft hole exceeds the specified quota;

(2) Cracks, unevenness or uneven wear on the wheel rolling surface;

(3) Wear of component journals exceeds 40%;

(4) The wear of the rim reaches more than 60% of the original thickness, and the uniform wear of the rolling surface reaches 15%-20% of the original rim thickness;

(5) Whether the radial wear of the wheel groove exceeds 32% of the wall thickness.

< 上一篇
没有了!

下一篇 >
没有了!